353ND use of the guidelines 
 EPOXY TECHNOLOGY ING by the United States. 353ND the use of plastic optical fiber light guide the process of practical application of technical guidelines for the user during use as a reference: 
 1.353ND storage 
 353ND PartA & B is not mixed and stored at room temperature, do not require refrigeration. If the 
 It is stored below 0 ° C, then A & B, mixed at room temperature the next time the temperature is at least 3-4 hours. This 
 The process is designed to prevent moisture in Epoxy water to prevent bubbles in the material curing. 
 2 353ND Part A & B, the mixing process 
 * If 353ND Part A & B packaged in 4 g of the A-pack plastic bags, A & B, have been pro rata 
 With packing a good mixing can be application only to the following steps: 
 Pressing hard on the A / removing the mandrel from the end of the component A, so that the resin can move to Group B seals. 
 B /. Pressing hard on the resin to break through the insulation layer can be between. 
 / The end of the fixed plastic bag resin from start to finish operation, until the group A and group B completely 
 Mixed so far. 
 The D / plastic bags end of the cut extrusion mixed good 353ND to apply. 
 * If 353ND Part A & B packaging large quantities of packaging (eg cans, plastic bottles or glass bottles, etc.), 
 First you want to group A and group B, respectively, shake, then the the, PartA 10, and PartB 
 Cases on the glassware mixture evenly so far. If mixed to produce a large number of bubbles, 
 Deaeration procedures in to the application. The defoaming way vacuum defoaming and centrifugal defoaming two. 
 The 353ND mixing time (Pot Life) can be used and amount of 
 353ND blend can be used for 4 hours to control the usage, so that the resin technology 
 Achieve the best performance. Because all of the epoxy resin in the mixed, beyond the use of time 
 Its viscosity will change and affect the adhesive force. Epoxy Technology Inc. is recommended that each make 
 The dosage is best not more than 25 grams. 
 (4) curing time 
 Epoxy Technology Inc. offers the following curing time and temperature data for user reference 
 Use 
 60 ° C for 1.5 hours 
 80 ° C for 15 minutes 
 100 ℃ and 5 minutes 
 120 ℃ 2 minutes 
 150 ℃ 1 minute 
 353ND curing the situation is at first 10 seconds at 150 ° C or 200 ° C curing, so the above attached 
 Reinforcement of temperature and time is for reference only, at the same time curing itself a part of the heat. In 
 Under normal circumstances, is not recommended to cure at temperatures above 150 ° C, preferably 150 ° C for 1 minute 
 Or 80 ℃ for 15 minutes to cure. However, the actual curing time should test products on to 353ND the solid 
 Reaction prevail.